Print at 100% scale (no scaling) • Verify ruler accuracy before use
IMPORTANT: This ruler must measure exactly 6 inches when printed. If not, adjust printer settings.
For cabinet doors and drawers with single knobs. Black dot shows drill location.
Most common spacing. Black dots show drill locations.
For larger doors. Black dots show drill locations.
Standard drawer pull spacing. Black dots show drill locations.
1. Print Verification: Measure the ruler on page 1. It must be exactly 6 inches.
2. Choose Template: Select the template matching your hardware spacing.
3. Position: Tape template to cabinet door/drawer face.
4. Mark: Use sharp pencil through black dots to mark drill points.
5. Drill: Use 1/8" pilot holes, drill from front face.
6. Install: Attach hardware with provided screws.
• Always test on scrap wood first
• Use drill press or guide for straight holes
• Drill pilot holes smaller than screw diameter
• Maintain consistent height across all cabinets
• Double-check measurements before drilling